HSRP Configuration on Packet tracer


Hot Redundancy Router Protocol (HSRP) provides network redundancy for IP networks, ensuring that user traffic immediately and transparently recovers from first hop failures in network edge devices or access network.

In this Blog we will configure the HSRP on two router as per the network diagram.

Network Diagram:



Firstly We will start the configuration on R1 after that We will configure R2.
We have two subnets for this topology first subnet 192.168.10.0/24 we are using for internal network , Second subnet 63.64.57.0/24 we are using for outside Network.Lets start the configuration.

Configuration on R1:

Router>en
Router#
Router#config t
Router(config)#hostname R1
R1(config)#Int fastEthernet 1/0
R1(config-if)#ip address 192.168.10.1 255.255.255.0
R1(config-if)#no shutdown 
R1(config-if)#standby 1 ip 192.168.10.100
R1(config-if)#Standby 1 priority 110
R1(config-if)#Standby 1 preempt 
R1(config-if)#Standby 1 track fastEthernet 0/0
R1(config-if)#no shutdown 
R1(config-if)#int f0/0
R1(config-if)#ip address 63.64.57.1 255.255.255.0
R1(config-if)#no shutdown 
R1(config-if)#exit
R1(config)#exit
R1#wr memory 
Building configuration...
[OK]

Configuration on R2:

Router>
Router>en
Router#
Router#config t
Router(config)#hostname R2
R2(config)#Int fastEthernet 1/0
R2(config-if)#Ip address 192.168.10.2 255.255.255.0
R2(config-if)#no shutdown 

R2(config-if)#standby 1 ip 192.168.10.100
R2(config-if)#standby 1 priority 100
R2(config-if)#standby 1 preempt 
R2(config-if)#standby 1 track fastEthernet 0/0
R2(config-if)#no shutdown 
R2(config-if)#exit
R2(config)#Int fastEthernet 0/0
R2(config-if)#ip address 63.64.57.3 255.255.255.0
R2(config-if)#no shutdown 
R2(config-if)#exit
R2(config)#do wr mem
Building configuration...
[OK]

Verify HSRP:






No comments